← Back to blog

Pitched roof renovation: thin, light and efficient

Pitched roof renovation: thin, light and efficient

When you replace your roof covering, it is also the right time to improve the roof’s thermal insulation. With the puren Ökonomic system you install it above the rafters – thin, light and without any work in the living spaces below.

The right thickness, construction and material for renovating pitched roofs have been debated for a long time, while the complexity of the renovation itself is often forgotten. As a result, the energy renovation of pitched roofs has lagged behind what is needed for years: to reach climate targets, far more than three percent of the building floor area would have to be renovated every year.

There are many reasons for hesitation, and for many homeowners one of them is the fear that the roof will become a “money pit”. This is why puren developed the puren Ökonomic system for pitched roof renovation – a simple, cost-effective solution tailored to renovation.

puren Ökonomic – a simple, universal renovation system

When the roof covering is replaced, puren Ökonomic is in most cases a cost-effective and very simple way to improve the energy performance of the roof. This applies especially to inhabited lofts, because both the airtight layer and the additional insulation are installed above the rafters. The building elements below and between the rafters – and therefore the living spaces – remain untouched. Existing insulation between the rafters that is still usable is kept and becomes part of the renovation concept.

The system is suitable for all roof shapes and pitches and for all usual thicknesses of between-rafter insulation from 80 to 200 mm. There is no need to top up or replace the insulation between the rafters, let alone enlarge the rafter cross-sections.

puren Ökonomic insulation board with factory-applied vapour-permeable membrane

The puren Ökonomic board is a rigid polyurethane foam (PIR) insulation board faced with a special fleece on both sides. On top it has a factory-applied vapour-permeable membrane (sd 0.1 m) with self-adhesive joints, which acts as a secondary roof covering.

Tongue-and-groove edges on the long and short sides ensure joints without thermal bridges. Thanks to its low weight, the board is easy to install and does not load the roof structure.

How a roof is renovated with puren Ökonomic

Roofer bonding self-adhesive joints on a roof insulated with puren Ökonomic

The renovation is done in two main steps: first the airtight layer, then thin thermal insulation over the entire surface. Because all the work is done from the outside of the roof, the living spaces remain untouched.

  1. Remove the old covering. Remove the roof covering and battens; existing insulation between the rafters that is still usable stays in place.
  2. Vapour control layer on the rafters. Lay the Ökonomic Hygrotop renovation membrane directly on the rafters. It acts as a convection barrier and provides the necessary airtightness.
  3. Insulation over the entire surface. Lay the puren Ökonomic boards on top; they are joined at the edges with tongue and groove.
  4. Sealed joints. Bond the joints of the factory-applied vapour-permeable membrane; depending on the design, this provides additional protection against rain.
  5. Counter battens, battens and new covering. Finally, install the counter battens, battens and the new roof covering.
Roof build-up with puren Ökonomic: insulation between rafters, Ökonomic Hygrotop membrane, puren Ökonomic boards, battens and covering

Thin, but sound in terms of building physics

The thickness of the above-rafter insulation depends mainly on the thickness of the insulation between the rafters: as thin as possible, but as thick as necessary for the whole system to be sound in terms of building physics. Thanks to its excellent insulating performance, just 60 or 80 mm of puren Ökonomic is enough to keep the rafter cross-sections warm and dry.

Cross-section of a roof with puren Ökonomic above the rafters and mineral wool between the rafters

Only on very cold days does a little condensation briefly form on the Ökonomic Hygrotop membrane. Because the whole system is open to diffusion, the moisture dries quickly – without damage and without an increased risk of mould, as confirmed by building physics experts.

Insulation of optimised thickness not only looks slim, it also does not strain your budget unnecessarily – and thanks to its low weight, it does not strain the roof structure either.

Which thickness? U-value table

The table shows the roof U-value for combinations of puren Ökonomic and insulation between the rafters (mineral wool with a thermal conductivity of 0.035 or 0.040 W/(m·K)). The manufacturer’s calculation applies to locations in Slovenia up to 700 m above sea level.

Table of roof U-values for combinations of puren Ökonomic and insulation between rafters

According to the manufacturer, in the vast majority of combinations just 80 mm of puren Ökonomic meets the minimum requirements of the Slovenian Rules on the Efficient Use of Energy in Buildings (PURES 2022). For more ambitious energy renovations a 100 mm thickness is also available: with 140 mm of insulation between the rafters it achieves a U-value of 0.134 or 0.141 W/(m²·K) – often just two or four centimetres “extra” are enough.

Eko sklad subsidy: what applies in 2026

In public call 126SUB-OB26, Eko sklad co-finances the insulation of pitched roofs on older buildings (building permit issued before 1 July 2010) at up to 40% of eligible costs, but no more than EUR 35 per m². The condition is a ratio of thermal conductivity to thickness of the new insulation of λ/d ≤ 0.140 W/(m²K); with several layers their thermal resistances are added up, and existing insulation is not taken into account.

If you keep the insulation between the rafters, puren Ökonomic alone does not meet this condition. You meet it if you also install new insulation between the rafters – for example 100 mm of puren Ökonomic (0.10/0.026 = 3.85 m²K/W) and 120 mm of new mineral wool with λ 0.035 (3.43 m²K/W), which together give 7.27 m²K/W, above the required 7.14 m²K/W. Check the current conditions at ekosklad.si before you invest.

Advice and supply at Marex

Marex offers puren insulation systems for pitched and flat roofs, including puren Ökonomic. We help you choose the right thickness for your existing roof structure, calculate the quantity needed and advise you on the choice of a new roof covering.